My Account
If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New Account
#SAVETHEFULLSIZEJEEP
A Portion Of The Proceeds From Your Purchase Supports The Development & Reproduction Of High Quality 1963-1991 Restoration Parts.
The Novak Dana 300 front output rear bearing caps were designed as an upgrade to eliminate any gear oil leaking from this location. The factory bearing/shim cover is one of the few notorious locations a leak can be found on the Dana 300 case. This is due to the shims being placed between the case & the cap, with only a copper spray-gasket applied to the shims to seal the cover.
The Novak shim/bearing cover utilizes a three tier O-ring setup to seal the case from leaking; two O-rings per bolt, one inside & one outside the cover, as well as one larger O-ring following the hole path inside the cap. This triple O-ring design is sure to eliminate your likely present oil leak at the bearing/shim cover. Installation of these kits is quite simple, especially with the help of the included detailed instructions.
Fits:
To submit a return or exchange request, please go to our Contact Us page to submit order information. Photos of any damaged products may be requested and required to process any full or partial refund. If approved, we will provide you with an RMA number along with a return label for shipping.
Parts returned that are not defective, are subject to a 25% restocking charge. JeepRecyclers.com/McDaniel Motor Co. is NOT responsible for any parts that have been altered, modified, disassembled, or damaged by misuse or an accident subsequent to the parts purchase.
Reconditioned parts come with a minimum warranty of 90 days, unless otherwise stated (Refer to product listing for warranty duration). The warranty is void if the parts are not returned in the same condition in which they are sold. Warranties for aftermarket parts are covered by the manufacturer.
What Are My Shipping Fees?
For orders delivered within the continental US where reason for return isn't a result of a JeepRecyclers.com/McDaniel Motor Co. error, the cost of the initial shipping charge and a return fee will be deducted from your refund. A prepaid shipping label(s) will be provided. The flat fee for each item being returned can be found in the chart below:
| Retail cost of the item | Per Item Return Fee |
|---|---|
| Less than $25.00 | $3.75 |
| From $25.00-$49.99 | $5.75 |
| From $50.00-$99.99 | $7.75 |
| More than $100.00 | $9.75 |
Crown Automotive Jeep Replacement
Front Output Shaft; Rear Bearing for Jeep SJ & J-Series (1980-1988) w/ NP208 Transfer Case. Jeep SJ & J-Series (1980-1986) w/ NP219 Transfer Case. Jeep SJ &...
Crown Automotive Jeep Replacement
Inner Pinion Bearing for Jeep SJ & J-Series 1971-1991 w/ Dana 44 Front or Rear Axle This Part Fits: Year Make Model Submodel 1974-1983 Jeep Cherokee
Crown Automotive Jeep Replacement
Rear Inner Output Shaft Bearing Cup for Jeep SJ & J-Series 1962-1979 w/ Dana 20 Transfer Case This Part Fits: Year Make Model Submodel 1974-1979 Je
Crown Automotive Jeep Replacement
Transfer Case Front Output Shaft Bearing for Jeep SJ & J-Series 1962-1979 w/ Dana 20 Transfer Case. 2 Required. This Part Fits: Year Make Model Submodel 1974-1979 Jeep
Crown Automotive Jeep Replacement
Inner Pinion Bearing Kit for Jeep SJ & J-Series 1971-1991 w/ Dana 44 Front or Rear Axle This Part Fits: Year Make Model Submodel 1974-1983 Jeep Cherokee &
