null
×
close

Engine Cylinder Head Bolt Set - 8577

(No reviews yet) Write a Review
UPC:
00085347085774
Availability:
This part ships direct from the manufacturer, lead times, stock and shipping may vary.
Weight:
4.60 LBS
$219.92

#SAVETHEFULLSIZEJEEP

A Portion Of The Proceeds From Your Purchase Supports The Development & Reproduction Of High Quality 1963-1991 Restoration Parts.

Engine Cylinder Head Bolt Set - 8577

Engine Cylinder Head Bolt Set - 8577

$219.92
The Edelbrock #8577 bolt kit contain a complete set of the highest quality head bolts and hardened washers available. Cold-formed to ensure molecular integrity and heat treated prior to thread rolling and machining. Reduced diameter bolt heads eliminate the need for valve train removal to facilitate cylinder head re-torqueing. Hardened and parallel-ground washers are included. Rated at 170,000 p.s.i.

This Part Fits:

YearMakeModelSubmodel
1993-1998JeepGrand Cherokee
1993JeepGrand Wagoneer


ApplicationsChrysler:Magnum:318 (5.2L)/360 (5.9L)
DescriptionEdelbrock #8577 is a Head Bolt Kit for 1992+ Small-Block Chrysler 5.2L/5.9L "Magnum" Engines with Edelbrock 61767, 61769, 61779, & 61775 Performer RPM Cylinder Heads. Kit contains a complete set of Head Bolts & Washers for a pair of heads.
Description_TRAThe Edelbrock #8577 is made specifically for Chrysler Magnum V8; Installation is the same as for original equipment cylinder heads. Consult a service manual for specific procedures, if necessary.; Be sure that the surface of the block and the surface of the head is thoroughly cleaned to remove any oily film before installation. Use alcohol or lacquer thinner on a lint-free rag to clean.; Apply oil suitable thread lubricant to head bolt threads and the underside of bolt heads and washers.; Torque bolts to 95 ft/lbs in three steps (45-65-95), following the factory tightening sequence. A re torque is recommended after initial start-up and cool-down (allow 2-3 hours for adequate cooling).
RGLWARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.

To submit a return or exchange request, please go to our Contact Us page to submit order information. Photos of any damaged products may be requested and required to process any full or partial refund. If approved, we will provide you with an RMA number along with a return label for shipping.

Parts returned that are not defective, are subject to a 25% restocking charge. JeepRecyclers.com/McDaniel Motor Co. is NOT responsible for any parts that have been altered, modified, disassembled, or damaged by misuse or an accident subsequent to the parts purchase.

Reconditioned parts come with a minimum warranty of 90 days, unless otherwise stated (Refer to product listing for warranty duration). The warranty is void if the parts are not returned in the same condition in which they are sold. Warranties for aftermarket parts are covered by the manufacturer.

What Are My Shipping Fees?

For orders delivered within the continental US where reason for return isn't a result of a JeepRecyclers.com/McDaniel Motor Co. error, the cost of the initial shipping charge and a return fee will be deducted from your refund. A prepaid shipping label(s) will be provided. The flat fee for each item being returned can be found in the chart below:

Retail cost of the item Per Item Return Fee
Less than $25.00 $3.75
From $25.00-$49.99 $5.75
From $50.00-$99.99 $7.75
More than $100.00 $9.75

More

to top